A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
Stopping the water source is priority one before any extraction begins.
Our Ault, CO crews trace pressure loss to identify the failure point before opening drywall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Our Ault, CO team works alongside your plumber or one we can refer, so the repair and drying stay coordinated.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Ault, CO crews run it.
If the source is still running, shutoff is priority one.
Diagnostics narrow down the exact wall section affected.
Wall cavity extraction addresses moisture a surface-level approach would miss.
We remove only the insulation and drywall sections that moisture readings confirm are compromised.
We dry wall framing directly, not just the room's ambient air.
Plumbing repair coordination is included so you're not managing two separate contractors.
Tell our Ault, CO dispatcher if the water source is still running so we can advise on shutoff immediately.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
Only the compromised section comes out, not the full wall.
We handle the water damage mitigation and coordinate directly with a licensed plumber for the pipe repair itself.
Turning off the water source, if accessible, limits damage before we arrive.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
Our Ault, CO teams cover Ault and surrounding areas with wall-cavity extraction equipment ready for dispatch.
One call gets a Ault, CO crew routed to Ault with the right equipment.
Call +1-844-578-1604